Epson Stylus Pro 7400 - Page 184

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Troubleshooting Troubleshooting based on Panel Messages 184
PAPER SETTING ERROR
LOAD ROLL PAPER
PAPER SETTING ERROR
LOAD CUT SHEET PAPER
CONVERSION CRTG LIFE
REPLACE CONVERSION CRTG WITH A NEW ONE
INK OUT
INSTALL NEW CARTRIDGE
INK CARTRIDGE ERROR
CHECK CARTRIDGE
Description Remedy
The roll paper is not set correctly.
The paper path number specified by the
remote command is different from the paper
type set by the panel.
The paper path sent by the remote command
is prioritized and the printer causes the error
according to the command if the paper path
setting of the printer does not match with that
of the remote command.
If the loaded paper type is different from the
panel setting, change the panel setting
accordingly.
Description Remedy
The cut sheet paper is not set correctly.
The paper path number specified by the
remote command is different from the paper
type set by the panel.
The paper path sent by the remote command
is prioritized and the printer causes the error
according to the command if the paper path
setting of the printer does not match with that
of the remote command.
Press the [Pause] button to reset the panel
setting. In this case, the panel setting is
returned to the default set by the printer.
Description Remedy
The conversion cartridge reached the end
of its life.
The number of times that the Conversion
Cartridge is used exceeded 100 times.
Replace the conversion cartridge with a new
one.
Or press the [Pause] button to continue the
black ink replacing operation.
Description Remedy
The ink cartridge is empty
All of the ink in the ink cartridge was used.
Replace the ink cartridge with a new one.
Description Remedy
The black cartridge is wrong (Photo Black
or Matte Black).
A black ink cartridge different from that
specified in the printer is installed.
Replace the black ink cartridge with the one
specified by the printer.
Or press the [Pause] button and change the
black ink type setting of the printer.
The product code of the ink cartridge is
wrong.
The product code of the installed ink
cartridge is wrong (except the photo black/
matte black mismatching error)
Replace the ink cartridge with a correct one.
Although the printer can recover from the
error by pressing the [Pause] button, it is not
recommended because it results in mixing-up
the different type of inks.