Epson Stylus Pro 7400 - Removing the Paper Feed Mechanism

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 252
4.2.6 Removing the Paper Feed Mechanism
4.2.6.1 VACUUM FAN ASSY.
1. Remove the P GUIDE L ASSY. See Section 4.2.3.7 on page 227.
2. Remove the FRONT COVER ASSY. See Section 4.2.3.9 on page 230.
3. Remove the screw that secures the TUBE COVER. See Figure 4-74.
 One C.P.S.(S-P2) M3 x 8 screw
4. Slide the TUBE COVER leftward to release it from the two hooked tabs, and
remove the TUBE COVER. See Figure 4-74.
5. Release the two hooked tabs on each of the seven PAPER OUTLET ROLLER
Assies, and remove them. See Figure 4-75.
Figure 4-74. Removing the TUBE COVER
Figure 4-75. Removing the PAPER OUTLET ROLLER ASSY.
C A U T I O N
When performing the next step, use a screwdriver whose length is
shorter than 15 cm.
C A U T I O N
When reinstalling the TUBE COVER, be careful not to trap TUBE,
SUPPLY, INK under the cover.
C H E C K
P O I N T
The Stylus Pro 7400/7800 have four PAPER OUTLET ROLLER
Assies.
Hooked tabs
TUBE COVER
C.P.S.(S-P2) 3x6
Hooked tabs
PAPER OUTLET ROLLER ASSY.