Epson Stylus Pro 7400 - Destination Setting

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Advanced Adjustment 360
5.4.3 Destination Setting
 Procedure
1. Turn the printer ON.
2. Start up the Adjustment Program and select [Change Model Name].
3. Select the [Others] and click the [Run] button to set the destination setting
onto the NVRAM.
4. Click the [Next] button.
5. Click the [Check] button to display the currently set model name. After
confirming the name, click the [OK] button.
6. Click the [Finish] button.
Figure 5-92. [Destination Setting] Screen (1)
Figure 5-93. [Destination Setting] Screen (2)
Figure 5-94. [Destination Setting] Screen (3)