Epson Stylus Pro 7400 - Adjustment Program Basic Operations

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Overview 300
5.1.7 Adjustment Program Basic Operations
This section describes the basic operations of the Adjustment Program.
 System Requirements
 OS: Windows 98SE, Me, 2000, XP
 Interface: USB
 The printer driver and EPW3 must have been installed.
 Startup
1. Double-click on “adjwiz2.exe” to start the Adjustment Program.
2. A startup screen will appear. Select the printer name and the port.
z Printer Name (and the port)
Stylus Pro 7400, Stylus Pro 7800, Stylus Pro 9400, Stylus Pro 9800
z Mode
Select the mode between the sequential and individual modes.
3. Click the [Start] button.
Figure 5-1. Adjustment Program Startup Screen
 Sequential mode
By selecting a part you replaced or repaired, this mode guides you to perform all
the required adjustments in a predetermined sequence.
1. Highlight the part you replaced or repaired in the left box and click the [Add]
button.
2. Click the [OK] button.
Figure 5-2. Sequential Mode
 Individual mode
This mode allows you to select and perform an adjustment individually.
1. Highlight the target adjustment item and click the [OK] button.
Figure 5-3. Individual Mode
C A U T I O N
The Adjustment Program includes some adjustment items which
should not be performed at on-site service. Be sure not to perform
any adjustments that are not described in this manual at on-site
service.