Epson Stylus Pro 7400 - Print Head Slant Adjustment (CR)

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 325
5.3.9 Print Head Slant Adjustment (CR)
 Paper Used
 Size: 24” (Stylus Pro 7400/7800)
44” (Stylus Pro 9400/9800)
 Type: Premium Glossy Photo Paper
 Procedure
1. Turn the printer ON.
2. Start up the Adjustment Program and select [Print Head Slant Adjustment
(CR)].
3. Click the [Print] button to print the adjustment pattern.
Figure 5-37. [Print Head Slant Adjustment (CR)] Screen (1)
4. Examine the printout patterns with its print start side facing downward.
5. Measure the two intervals of dot-lines in any one of the patterns shown in
Figure 5-38 with a calibrated magnifying glass.
z The two intervals are the same: No need to make the adjustment. Click the
[Next] button twice to display the Screen 3 (Figure 5-41) and click the
[Run] on the screen. The Carriage Unit will return to its home position and
the roll paper will be reeled off.
Click the [Finish] button to exit out of the adjustment menu.
z The two intervals are Not the same: Proceed to Step 6.
Figure 5-38. Adjustment Pattern
1
A
A < B
2
A = B
3
A > B
B
A
B
A
B
Paper Feed Direction