Epson Stylus Pro 7400 - Removing the Panel Unit and Housing

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 220
4.2.3 Removing the Panel Unit and Housing
4.2.3.1 PANEL ASSY.
1. Unlock the CARRIAGE ASSY. and move the unit to the center. See Section on
page 215.
2. Release the two hooked tabs that secure the PANEL ASSY. from the inner side,
and remove the PANEL ASSY. See Figure 4-16.
3. Disconnect the FFC from the PANEL ASSY. See Figure 4-17.
Figure 4-16. Hooked Tabs for Securing the PANEL ASSY.
Figure 4-17. Removing the PANEL ASSY.
C A U T I O N
When performing the next step, be careful not to pull the PANEL
ASSY. too much as it is still connected to the printer with the FFC.
First attach the two hooked tabs of the PANEL ASSY. to the R
SIDE COVER ASSY., and then push the front side edge of the
PANEL ASSY. into the R SIDE COVER ASSY.
Figure 4-15. Reinstalling the PANEL ASSY.
R SIDE COVER ASSY.
Hooked tabs
PANEL ASSY.
Connector
FFC