Epson Stylus Pro 7400 - Time out

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 68
1.4.4.10 Paper Skew Check
When this is set to “ON”, the printer automatically detects that a paper is loaded or fed
at an angle and causes a paper skew error. If this is set to OFF, the error does not occur
and printing is continued even if the paper is loaded at an angle or skewed during
printing causing a off-paper printing. Although this menu is disabled when “cut sheet”
is selected as paper source, the printer can detect a skewed cut sheet when starting
printing if the Paper Size Check function is set to ON. If a cut sheet is skewed during
printing, however, it cannot be detected.
 Paper Skew Check menu
1.4.4.11 Time Out
This menu allows you to select a time period for job time out from five options. When
a transmission of print job from the host is interrupted for the set time period, the
printer judges that the job is finished and ejects the paper.
This setting is ignored when the host sends a duplex print job with the interface
specified.
 Time Out menu
[ ]
Setting
Setting
PAPER SKEW CHECK
ON
OFF
PAPER SKEW CHECK
ON
OFF
PRINTER SETUP
PAPER SIZE CHECK
PAPER SKEW CHECK
TIME OUT
Setting
Setting
Setting
Setting
Setting
TIME OUT
OFF
30sec
60sec
TIME OUT
OFF
30sec
60sec
TIME OUT
30sec
60sec
180sec
TIME OUT
60sec
180sec
300sec
TIME OUT
60sec
180sec
300sec
PRINTER SETUP
PAPER SKEW CHECK
TIME OUT
CUTTER ADJUSTMENT