Epson Stylus Pro 7400 - Page 26

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Basic Specifications 26
1.2.5.3 Cut Specifications
Both automatic and manual cut are available on this printer.
ROLL PAPER AUTOMATIC CUT
This function is enabled by setting “Roll Auto Cut” in the Panel Setting menu to ON.
 Mechanical condition
 Distance between the cutting position and paper setting position:L0 = 187mm
 Distance between the cutting position and cutter mark: L1 = 34mm
 Minimum cut length: L2 = 127mm
 Sheet edge standby location: L3 = 130mm
ROLL PAPER MANUAL CUT
The automatic cutting prohibited media can be cut manually following the procedure
described below.
1. Press the [Paper Select ] button to select the [Roll Auto Cut Off ] and press
the [Enter ] button.
2. Paper is automatically fed to the cutter guide, then the printer will go offline. At
this point, “PAUSE” will be displayed on the panel.
3. If required, fine adjustments on the cut position can be performed using the [Paper
feed ( )] buttons.
4. The user can then use the manual cutter unit and cut the paper along the cutter
guide.
5. After cutting the paper, cancel the pause status (press the [Pause] button). The
paper will back feed and the printer will go back online.
1.2.5.4 Paper Set Lever
C A U T I O N
There are some types of media which are not allowed to be cut
automatically. Be sure not to perform the automatic cutting with
them, or may result in damaging the printhead.
C H E C K
P O I N T
For manual cutting of roll paper, use the manual cutter available as
an option.
Table 1-15. Paper Set Lever
Lever Position Description
Backward Position for paper setting
(Paper holding is released, and paper can be set.)
Forward Ready-to-print position
(Paper is fixed, and it becomes ready to be printed.)