Epson Stylus Pro 7400 - Page 262

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 262
4.2.6.6 P Rear Sensor
1. Remove the P Thick Sensor Mounting Plate. See Section 4.2.6.5 on page 261.
2. Disconnect the FFC from the connector.
3. Release the two tabs that secure the P Rear Sensor and remove it.
Figure 4-95. Removing the P Rear Sensor
A D J U S T M E N T
R E Q U I R E D
Whenever the P Rear Sensor is reinstalled or replaced, the
corresponding adjustment must be carried out. See Chapter 5 on
page 292.
FFC
Connector
Tabs
P Rear Sensor