Epson Stylus Pro 7400 - Page 295

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Overview 295
PF Motor 1 PF Timing Belt Tension Adjustment {{p.307
2 T&B&S + 980mm Band Feed { { p.318
3 Reset PF Motor Counter { --- p.367
Paper Thickness
Sensor
1 Paper Thickness Sensor Position
Adjustment
{ { p.304
Ink Mark
Sensor
1 Ink Mark Sensor Height Adjustment {{p.301
2 Ink Mark Sensor Level Adjustment { { p.328
3 T&B&S (Roll Paper) { --- p.316
4 Platen Position Adjustment { { p.334
5 Ink Mark Sensor Adjustment for Auto
Nozzle Check
{{p.331
6 Auto Uni-D Adjustment { { p.329
7 Auto Bi-D Adjustment {{p.357
CR Encoder
Sensor
1 CR Encoder Sensor Adjustment { --- p.308
Rear Sensor 1 Rear Sensor Adjustment { --- p.340
PF Encoder
Sensor
1 PF Encoder Sensor Adjustment { --- p.309
2 T&B&S + 980mm Band Feed { --- p.318
Ink Tube 1 Air leak check { { p.310
Ink
Cartridge
Slot
1 Air leak check {{p.310
Cutter
Solenoid
1 Cutter Position/Height Adjustment { { p.302
2 Cutter Pressure Adjustment {{p.320
Table 5-2. Required Adjustments in the Order of Execution (continued)
Part Name Required Adjustment RP*
1
RM*
2
Page