Epson Stylus Pro 7400 - Page 298

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Overview 298
ADVANCED ADJUSTMENT
CHECK RESULTS
RESET COUNTERS
Adjustment General Overview
Tool
Page
AU*
1
SM*
2
AT*
3
Auto Bi-D Adjustment Performs an automatic Bi-D adjustment by the Ink Mark Sensor. The adjustment patterns are printed out with
the platen gap set at 0.8 and 1.6.
{ --- --- p.357
Manual Bi-D Adjustment Makes Bi-D adjustments for all nozzles. { --- --- p.358
Destination Setting Makes the destination settings. { --- --- p.360
PF Micro Feed Adjustment (Bi-D) Adjusts a paper feed amount to reduce bands appear on prints. { --- --- p.361
Adjustment General Overview
Tool
Page
AU*
1
SM*
2
AT*
3
Check Nozzle Checks the nozzles for clogging. { --- --- p.362
Check Alignment Checks the print alignment. { --- --- p.363
Print Adjustment Check Pattern Prints all adjustment parameters and patterns. { --- --- p.364
Check Cutting Performs a roll paper cutting operation. The cutter performance can be checked. { --- --- p.365
Print Image Prints a sample image. Print quality can be checked. { --- --- p.366
Adjustment General Overview
Tool
Page
AU*
1
SM*
2
AT*
3
Reset PG Switching Counter Resets the PG switching counter. { --- --- p.367
Reset PF Motor Counter Resets the cumulative travel distance of the PF Motor. { --- --- p.367
Reset When CR Unit Change Resets the cumulative number of “Pass” times of the CR Motor. { --- --- p.368
Reset When Cleaning Unit Change Resets the life counter of the Cleaning Unit. { --- --- p.368
Reset When PrintHead Change Resets the life counter of the Printhead. { --- --- p.369
Reset When Cutter Solenoid Change Resets the counter of the Cutter Solenoid Unit. { --- --- p.369
Reset Pump Counter Resets the counter of the Pump Unit. { --- --- p.370
Reset Ink Information Resets ink information set for each nozzle column. { --- --- p.370