Epson Stylus Pro 7400 - Page 30

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Basic Specifications 30
1.2.8.2 Vibration Resistance
 Operating: 0.15 G, 10 to 55 Hz in X, Y, Z direction
 Store: 0.50 G, 10 to 55 Hz in X, Y, Z direction
1.2.8.3 Shock Resistance
 Operating: 1G within 1 millisecond in X, Y, Z direction
 Store: 2G within 2 milliseconds in X, Y, Z direction
NOTE • Check that the printhead is capped when storing the printer for a long
period of time.
• When transporting the printer, check that the printhead is capped, all ink
cartridges are removed, and the ink cartridges covers are closed and fixed.
• If the printhead are not capped, turn the power back ON with the ink
cartridges installed, and then turn the power OFF again after confirming
the capping operation is complete.
• If the printer is left under an ambient temperature of minus 15
° C, ink inside
the printhead and ink cartridges will freeze.
If this happens, move the printer, or heat the room so that the ambient
temperature is 25
° C, and leave the printer under the temperature for
approximately 3 hours to melt the ink.