75
When you press the stop button and no other cartridges need to be replaced, the print head
moves to its home position and the printer starts charging the ink. This takes about 1 1/
2 minutes.
When the power light stops flashing and remains on and the error and ink lights go
out, ink charging is finished.
Caution:
Never turn off the printer while the power light is flashing or you’ll waste ink.
Note:
If you remove a low or expended ink cartridge, you cannot re-install and use the cartridge.
10. Close the ink cartridge cover, then close the document cover.
Note:
If the error and ink lights remain on after the print head moves to its home position, an ink
cartridge may not be installed properly. Press the stop button again, and then press the ink
cartridge down until it clicks into place.
Caution:
If you remove an ink cartridge for later use, protect the ink supply area from dirt and dust and
store it in the same environment as the printer. Note that there is a valve in the ink supply port,
1
2
To Next Page
Loading...
