104
Specifications and Notices
For information about using your printer and detailed specifications, see:
Important Safety Instructions
Computer System Requirements
Product Specifications
Open-source Software Notices
FCC Compliance Statement
Copyright and Trademarks
Important Safety Instructions
Before using your printer, read and follow these safety instructions:
General Safety
Ink Cartridge Safety
General Safety
• Be sure to follow all warnings and instructions marked on the printer.
• Use only the type of power source indicated on the printer’s label.
• Use only the power cord that comes with the printer. Use of another cord may cause fires or
shock. Do not use the cord with any other equipment.
• Place the printer near a wall outlet where the plug can be easily unplugged.
• Avoid plugging the printer into an outlet on the same circuit as a photo copier or air control
system that regularly switches on and off, or on an outlet controlled by a wall switch or timer.
• Do not let the power cord become damaged or frayed.
• If you use an extension cord with the printer, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the
total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s
ampere rating.
• Always turn off the printer using the power button, and wait until the power light stops
flashing before unplugging the printer or cutting off power to the electrical outlet.
• Place the printer on a flat, stable surface that extends beyond its base in all directions. It will
not operate properly if it is tilted or at an angle.
• Make sure the back of the printer is at least 4 inches (10 cm) away from the wall.
• Leave enough space in front of the printer for the paper to be fully ejected.
• Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or
dust.
• Do not place the printer near a radiator or heating vent or in direct sunlight.
To Next Page
Loading...
Need help?
General
