136
6. Make sure the adjusters rest higher than the caster. If necessary, use the included wrench to loosen
the nut on top of the adjuster. Then turn the nut on the bottom counter-clockwise to raise the adjuster.
7. Move the product.
Caution: Roll the product on the casters for only a short distance over a level floor. Do not transport
the product using the casters. Do not tilt the product more than 10 degrees.
Parent topic: Moving or Transporting the Product
Related references
Maintenance Precautions
Related tasks
Replacing the Waste Ink Bottle
Related topics
Removing Printed Media
Setting Up the Product After Moving
Follow these steps to set up the product after moving it.
1. Verify that the location is suitable for installation.
To Next Page
Loading...
