64
4 Right margin
2
,
3
You select this margin as the total of the values for the Print Start Position (default setting is 0)
and Side Margin(Right) (default setting is 0.2 inch [5 mm]) settings on the product control panel.
You can select from 0.12 inch (3 mm) to 32.5 inches (825 mm).
5 Media width
11.8 to 64 inches (300 mm to 1626 mm); if Media Size Check is off, the product assumes this is
64 inches (1626 mm) regardless of the actual width.
1
The configured margin and the actual print results may differ depending on the RIP software you use.
Contact the RIP manufacturer for more information.
2
Depending on the RIP software, you may be able to use it to set these margins. Contact the RIP
manufacturer for more information.
3
When using the media holding plates, leave margins of at least 0.4 inch (10 mm) to avoid printing over
the plates. If the total of the print data width and the left and right margins exceeds the printable area, a
portion of the print data will not print.
Parent topic: Media Handling
Related references
Printer Setup Menu Settings
Print Start Positions
The print start positions determine where printing begins on the right and top sides of your media.
To Next Page
Loading...
