51
Printing the Amount of Media Remaining
After you print, you can print the amount of media remaining on the leading edge of the remaining roll.
This lets you enter the number the next time you load the media for the most accurate accounting of the
media remaining on each roll
Note: You must have turned on the Remaining Setup setting on the product control panel to calculate
the amount of media remaining.
1. Make sure your product is ready to print.
2. Press the media setup button, select Media Remaining in the displayed menu, and press the OK
button.
3. Select Print Remaining Length and press the OK button.
4. Press the OK button to print the amount of media remaining.
Parent topic: Removing Printed Media
Related references
Media Setup Menu Settings
Cutting Media
When you finish printing, use a commercially available cutter to cut the media.
Warning: Be careful not to cut yourself when using cutters or other sharp blades. Also be careful
touching areas near the after heater since the after heater may be hot and you could be burned.
1. Press the media setup button.
To Next Page
Loading...
