54
5. Do one of the following:
• If you are not using the auto take-up reel, skip the remaining step.
• If you are using the auto take-up reel, go to the next step.
6. Set the Auto switch to off, then set the Manual switch to take up the cut media onto the take-up reel,
depending on the printable side of the media:
• Move the switch to the position for printable-side-out media.
• Move the switch to the position for printable-side-in media.
Parent topic: Removing Printed Media
Removing Media From the Auto Take-up Reel
After printing on media loaded on the auto take-up reel, follow these steps to remove it.
To Next Page
Loading...
