43
Take Up with the Printable-Side-In
After attaching the roll core on the auto take-up reel, follow these steps to take up media with the
printable side in.
1. Cut a strip about 27.6 inches (70 cm) long from the included paper tape and attach one end to the
center of the media using adhesive tape.
1 27.6 inches (70 cm)
Note: You can also use commercially available tape or strips cut from media to attach your media to
the roll core. The paper tape or cut media strip should be about 0.8 to 1 inch (20 to 25 mm) wide and
27.6 inches (70 cm) long.
To Next Page
Loading...
