63
1 Bottom margin
1
You can configure this margin in the RIP software from 0.2 inch (5 mm) to 0.7 inch (17 mm); if
you set it below 0.2 inch (5 mm) or above 0.7 inch (17 mm), it is changed to 0.2 inch (5 mm) and
0.7 inch (17 mm) respectively to maintain feeding accuracy.
2 Top margin
1
You can configure this margin in the RIP software to 0.2 inch (5 mm) and above; if you set it
below 0.2 inch (5 mm), it is changed to 0.2 inch (5 mm) to maintain feeding accuracy. The margin
differs depending on how far the media was pulled during loading.
3 Left margin
2
,
3
You select this margin as the Side Margin(Left) setting on the product control panel. The default
setting is 0.2 inch (5 mm), but you can select from 0.12 inch (3 mm) to 0.98 inch (25 mm).
To Next Page
Loading...
