147
6. Pull the media to the cutter groove and cut off the torn or creased media from the roll.
7. Manually rewind the media.
8. Remove any media that remains inside the product.
9. Turn the product back on, load media, run a nozzle check and, if necessary, clean the print heads.
Caution: Do not leave the product turned off with the print heads in an uncapped position for an
extended period. The print heads may dry out and the product may not print properly.
Parent topic: Solving Printing Problems
Related concepts
Print Head Maintenance
Related references
Media Setup Menu Settings
Related tasks
Loading Media
Replacing the Media Edge Plates
Related topics
Removing Printed Media
To Next Page
Loading...
