Rev. A General Information 1-15
TM-H6000II Technical Reference Guide
1.5.4 Receipt Section
Printing method: Thermal line printing
Dot density: 180 dpi
×
180 dpi [the number of dots per 25.4 mm {1"}]
Printing direction: Unidirectional with friction feed
Printing width: 72 mm {2.83"}, 512 dot positions
Paper width: 80 mm / 60 mm / 58 mm {3.15"/2.36"/2.28"}
NOTE: default setting is 80 mm {3.15"}.
58 mm {2.28"} or 60 mm {2.36"} paper width can be selected using
the roll paper spacer.
Characters per line: 42 (font A, default) 56 (font B) (When using 80mm width paper)
Character spacing: 0.28 mm {.01"} (2 dots) (font A, default)
0.28 mm {.01"} (2 dots) (font B)
Programmable by control command.
Print speed: Normal: 54 lps maximum (computed value for 1/8" feed)
170 mm/s maximum {Approximately 6.7"/s}
(at 24 V, density level 2)
* For the model with paper width 58 mm {2.28"}, 150 mm/s
{5.9"/s} maximum.
Ladder barcode/2-dimensional code printing:
114 mm/s maximum
Two-color print mode:
56.4 mm/s maximum
(at 24V, density level 2)
Paper feed speed: Approximately 170 mm/second {approximately 6.7"/second}
continuous feeding
Line spacing (default): 4.23 mm {1/6"}, programmable by control commands.
Number of characters: Alphanumeric characters: 95
International characters: 37
Extended graphics: 128
×
11 pages (including one space page)
Multilingual character model supports printing with one of the
following character sets:
Simplified Chinese (GB2312): 7580
Traditional Chinese (Big 5): 13494
To Next Page
Loading...
