Rev. A Setup 3-5
TM-H6000II Technical Reference Guide
The set up flow of preparing to use printer is below..
Note:
When you use OPOS (OCX driver from EPSON) or Advanced Printer Driver, you need to install the
driver. When you use ESC/POS commands, you don’t have to install drivers. For information on these
drivers, see “Control Method” on page 2-1 and “Install a Printer Driver in the Host PC / POS Terminal”
on page 3-25.
3.3 Printer setup
This section describes the setup. The flow of preparing to use printer is below
Complete set up
Printer setup (See “Printer setup,” page 3-5)
Printer customizing (See “Customizing,” page 3-16)
Driver setup
❏ OPOS
❏ APD
(See “Install a Printer Driver in the Host PC
/ POS Terminal,” page 3-25)
To Next Page
Loading...
