Epson TM H6000 - B/W Direct Thermal - Paper Roll Supply Device Section

Rev. A General Information 1-17
TM-H6000II Technical Reference Guide
1.5.4.2 Paper Roll Supply Device Section
Note:You can use the ESC c 4 command to stop printing upon detection of a paper near-end.
Supply method: Drop-in paper roll
Near-end sensor Detection method: Microswitch
Paper roll spool diameter:
Inside: 12 mm (.47")
Outside: 18 mm (.71")
Near-end adjustment: Adjusting screw
Remaining amount: Fixed position
#1 approximately 23 mm (0.9")
#2 approximately 27 mm (1.06")
(The adjusting screw has two positions.)
See Chapter 5.
Paper roll end detection Detection method: Reflective photo sensor