28
Installing the Printer
You can install the printer horizontally or vertically. You can also carry it using the belt clip on
the back of the printer to hang the printer on your belt.
Notes on Using the Wi-Fi Models
• Keep the printer away from the devices, such as kitchen microwaves, that may cause radio
wave interference.
• Use channels that are away from the frequency bands that may cause radio wave influence.
• Place shields between the printer and the devices that may cause radio wave interference.
• Select either 2.4 GHz or 5 GHz, whichever is free from radio wave interference.
• In auto channel setting for the access point, do not select a channel in which the printer may
cause radio wave interference.
When you install the printer vertically, only the orientation shown below is available. Do
not install the printer upside down.
When you install the printer horizontally, it is recommended to remove the belt clip.
Remove the two screws fixing the clip to remove it.
To Next Page
Loading...
