Chapter 2 Setup
29
2
Changing the Paper Width
The printer is initially set to print on 58 mm {2.28"} width paper. If you use 60 mm {2.36"} width
paper, remove the spacer installed in the printer. You can also install it again to use 58 mm width
paper.
Removing the Spacer
Follow the steps below to remove the spacer when you use 60 mm width paper.
1
Make sure that the printer is turned off.
2
Press the open button to open the roll paper cover.
When changing the paper width, be sure to change the setting for the paper width with the
customized value. To set the customized value, see "Software Settings" on page 44.
To Next Page
Loading...
