60
EpsonNet Config (Web Version)
EpsonNet Config (Web version) is a utility to configure the network and other settings on a web
browser.
Starting EpsonNet Config (Web Version)
Follow the steps below to start up EpsonNet Config (web version).
1
Start up a PC connected to the network.
2
Start up the web browser and input the printer’s IP address (http://
printer’s IP address) in the address bar as shown below.
http://xxx.xxx.xxx.xxx
You can check the printer's IP address from the dynamic status sheet or in self-test
mode. For details on printing the dynamic status sheet, see "Dynamic Status Sheet Print
Mode (Only for Wi-Fi Models)" on page 71. For details on the self-test mode, see "Self-
test Mode" on page 65.
A user name and a password will be required on the authentication screen. Enter
“epson” for both the user name and the password. You can change the password with
[Password] in the Optional configuration menu.
In the initial setting, a warning message for authentication may appear when you access
EpsonNet Config (web version) from a browser.
To Next Page
Loading...
