Chapter 2 Setup
37
2
Connecting the Printer
The TM-P60II has dual interfaces: a built-in USB interface and another interface selected by the customer,
wireless LAN or Bluetooth interface. See the corresponding section for the interface you selected.
• Wi-Fi models: "USB Interface" on page 37 or "Wireless LAN Interface" on page 39
• Bluetooth models: "USB Interface" on page 37 or "Bluetooth Interface" on page 40
USB Interface
When communicating with a host PC via the USB cable, connect the USB cable to the printer,
turn on the PC, and then turn on the printer. For Windows, you can change the printer settings
with the TM-P60II Utility. For details on the TM-P60II Utility, see
"Software Settings" on page 44.
Before connecting the printer, confirm the current interface mode. The printer is initially
set to the Automatic selection mode. To change the interface mode, see "Software
Settings" on page 44.
Automatic selection:
When the USB cable is connected with a host PC, the USB interface is preferentially
selected. Otherwise, the wireless LAN/Bluetooth interface is selected. Once the
interface is selected, the selection is enabled until the power is turned off or the USB
cable is disconnected.
Putting the USB cable through the wire saddle prevents the cable from coming
unplugged.
Do not place any weight or stress on the cable when using. Doing so could damage the
cable and connectors.
To Next Page
Loading...
