Chapter 3 Application Development Information
65
3
Self-test Mode
In the self-test mode, the printer prints the current status of the printer and resident characters as
a test print).
You can confirm the following information with the status print.
•ROM version
•Interface type
• Interface setting
• Built-in character sets
• Maintenance information (Print head running length, count of autocutting)
Starting the status print and test print
Follow the steps below to start a status print and test print on the roll paper.
1
Install the roll paper.
2
Close the roll paper cover.
3
While pressing the Feed button, turn on the printer. (Keep pressing the
button until the printer starts printing.)
The printer starts printing the current status of the printer on the roll paper.
When the printer finishes printing the printer status, the following message is printed and
the Paper LED flashes. (The printer is now in the self-test wait mode.):
“Select Modes by pressing Feed button.
Continue SELF-TEST: Less than 1 second
Mode Selection : 1 second or more”
4
To start the test print, press the Feed button less than 1 second.
The printer prints a rolling pattern on the roll paper, using only the built-in character set.
After printing the following message, the printer is initialized and returned to the normal mode.
“*** completed***”
If you select the mode selection, see "NV Graphics Print Mode" on page 67, "Software Set-
ting Mode" on page 68, "Radio Field Intensity Check Mode (Only For Wi-Fi Models)" on
page 70, or "Dynamic Status Sheet Print Mode (Only for Wi-Fi Models)" on page 71.
To Next Page
Loading...
