Chapter 2 Setup
47
2
Command execution during offline
When this function is enabled, you can execute specified commands even if the printer is offline
due to specified causes.
• Enabled (initial setting)
•Disabled
Autocutting at roll paper cover close
• Cuts (initial setting)
•Does not cut
Automatic paper reduction
• Extra upper space reduction: disabled (initial setting) or enabled
• Extra lower space reduction: disabled (initial setting) or enabled
• Line space reduction rate: not reduced (initial setting), 25%, 50%, or 75%
• Line feed reduction rate: not reduced (initial setting), 25%, 50%, or 75%
• Barcode height reduction rate: not reduced (initial setting), 25%, 50%, or 75%
Automatic power off time
Selectable from 1 to 60 minutes. (initial setting: Disabled)
Battery charge mode
• Mode 1 (initial setting)
•Mode 2
Paper reduction is not performed for space dot lines of graphics printing data.
When reducing barcode height, be sure to check reading a barcode with your barcode
reader in advance.
When using the USB interface, this functions is disabled even if the time is set.
For detailed information, see "Auto-Power Off" on page 19.
For detailed information about the battery charge mode, see "Battery Charge Modes" on
page 19.
To Next Page
Loading...
