Epson TM-S1000 Technical Reference Guide

Chapter 1 Product Overview
25
1
Other Sensors
Franking cartridge sensor (J)
This sensor detects whether the franking cartridge is installed or not.
Franking cartridge position sensor (K)
The franking cartridge is installed in the franking cartridge holder, and the franking operation is
achieved by a motor driving the cartridge holder. The scanner has a franking cartridge sensor for
detecting the position of the cartridge holder.
Pocket switch board sensor (L) (except for the one pocket model)
The scanner has two pockets, and a switch board for switching the direction of each of the
pockets. This sensor detects the position of the switch board.
Hopper position sensor (M)
This sensor is located in the ASF/SF. It detects the position of the hopper, which holds
documents in place.
Paper thickness sensor (N) (only for the multi feed models)
This sensor detects the level difference and thickness in order to determine whether or not paper
has been double fed.
Even if a double feed is detected, it is still possible to obtain MICR and image data that has
been read, and to carry out print electronic endorsements and franking.

Epson TM-S1000 Specifications

General

Film scanning	No
Grayscale levels	256
Input color depth	- bit
Maximum scan size	120 x 235 mm
Scanner type	Sheet-fed scanner
Sensor type	CIS
Scan media weight	60 - 120 g/m²
Dimensions (WxDxH)	160 x 355 x 176 mm
Standard media sizes	Length: 120 mm - 235 mm (approx 4.8 in - 9 in), Height: 68mm - 120 mm (approx 2.7 in - 4.8 in), Thickness: 0.075 x 0.2 mm (approx 0.003 in - 0.008 in), Weight: 60 - 120 g/m2 (approx 16lb - 32lb)

Weight and Dimensions

Depth	355 mm
Width	160 mm
Height	176 mm
Weight	4000 g