Epson TM-S9000MJ - Recoverable Errors

Chapter 1 Product Overview
27
1
Recoverable Errors
Processing is no longer possible when recoverable errors occur. They can be recovered easily by
sending an error recovery command from the driver after eliminating the cause of the error.
* The memory switch must be set to recoverable error.
Error Error description
Error LED flash code
Recovery measure
Roll paper cover
open error*
While printing on the roll
paper, the roll paper
cover was opened.
Recovers with a
command with the roll
paper cover closed.
Mechanism
position error
The home position of the
hopper or the pocket
switching board cannot
be detected.
Recovers with a
command after the
error cause is
eliminated.
Cut sheet paper
jam error
 The check is not ejected
after feeding a specified
amount of paper.
 Feeding from the ASF
failed.
 A cut sheet paper/card
jam was detected.
 Too short/long paper
was detected.
Recovers with a
command after the
error cause is
eliminated.
Cut sheet paper
feed error
 Double feeding of cut
sheet paper occurred.
 Cut sheet paper was
inserted upside down or
back to front.
 Selected that incorrect
cut sheet paper feeding
to cause an error in
confirmation mode.
 Data that is longer than
the length of the cut
sheet paper was
specified.
 Noise was detected
during MICR reading.
Recovers with a
command after the
error cause is
eliminated.
Auto-cutter error The home position of the
auto-cutter cannot be
detected.
Recovers after the
error cause is
eliminated.
Approx. 320 ms