Chapter 4 Handling
83
4
Cleaning the MICR Head
When the MICR head becomes dirty, the product cannot read the magnetic ink characters
normally.
Clean the MICR head every 6 months or every 100,000 passes by setting the following cleaning
sheet in the same way as cut sheet paper. (See
"Inserting Cut Sheet Paper" on page 78.)
•KIC Team, Inc. “Waffletechnology
®
cleaning card” (CS1B15WS)
•KIC Team, Inc. "Epson Check Scanner Cleaning Kit" (Model: KWEPS-KCS2)
Use a cleaning sheet only one time; then discard it.
Cleaning the Scanner
If the glass of the scanner gets soiled from ink or paper dust, the quality of scanned data may
deteriorate. Clean the glass every 6 months or every 100,000 passes by following the steps below.
1
Open the scanner cover.
See "Opening the Scanner Cover" on page 76.
It is recommended to clean the MICR head once per week or once every 2,000 sheets
for good reading results.
It is recommended to clean the scanner after cleaning the MICR head.
CAUTION
Do not use synthetic detergent, benzine, water, or other liquid for cleaning.
Doing so may result in a stain.
Never apply any liquid directly to the glass of the scanner.
To Next Page
Loading...
