Epson TM-S9000MJ - Processing Cut Sheet Paper; Flow of Single Pass Processing; Important Notes on Processing Cut Sheet Paper

Chapter 4 Handling
77
4
Processing Cut Sheet Paper
The TM-S9000MJ is capable of performing the following actions on cut sheet paper in a single
pass.
Flow of Single Pass Processing
Auto sheet feeder (ASF) section feeds the cut sheet paper. (➀)
MICR reader section reads magnetic ink characters on the cut sheet paper. (
➁)
Printer section prints on the cut sheet paper.(
➂)
Scanner section scans both sides of the cut sheet paper.(
➃)
Pocket section ejects the processed cut sheet paper.(
➄)
Important Notes on Processing Cut Sheet Paper
•Use cut sheet paper that meets the specifications. (See "Paper Specifications" on page 39.)
•Do not use copy paper or other multi-ply paper.
•Make sure that the cut sheet paper has no curl, bending (especially on the corners), warpage,
or wrinkles.
•Do not use checks with paper clips, staples, adhesive tape, or other foreign materials attached.
•Be sure to let cut sheet paper go as soon as the scanner starts feeding. Ot
herwise, there may be
a paper skew, paper jam, or MICR reading error.
•Do not open the covers while processing is in progress.
1
2
3
4
5