Chapter 4 Handling
89
4
Preparing for Transport
Follow the steps below to transport the product.
Install the transportation cartridge
If transporting a product for which the initial ink filling has been done, install the transportation
cartridge and transport it. Failure to do so may cause ink leaks.
Transportation cartridge: TRANSPORTATION CARTRIDGE, SJIC18, UNIT
1
Turn on the product.
See "Turning On" on page 73.
2
Open the ink cartridge cover.
See "Opening the Ink Cartridge Cover" on page 74.
3
Remove it by pulling up the tab on the top of the cartridge while holding
the product.
4
Install the transportation ink cartridge in the correct direction, and push
it until it clicks in place.
5
Close the ink cartridge cover.
Pack the scanner
1
Turn off the product.
See "Turning Off" on page 73.
2
Confirm that Power LED is off.
3
Remove the power supply connector.
4
Store the ASF guide and the pocket guide inside the scanner.
5
Pack the scanner upright.
Keep the product upright and horizontal during transportation.
To Next Page
Loading...
