72
Memory Switch Setting Mode
In the memory switch setting mode, you can set the following “memory switches (customized
values),” which are software switches of this printer.
•Receipt print density
•Automatic paper reduction
•Autocutting at roll paper cover close
•Automatic line feed
• Error control
•Power on notice
•Remote wake-up
Starting the memory switch setting mode
Follow the steps below to run this mode.
1
Install the roll paper.
2
With the roll paper cover opened, while pressing the Feed button, turn
the power on. (Keep pressing the button until the Error LED lights.)
3
Close the roll paper cover.
The printer starts printing instructions. Follow them.
After one setting has been completed, the printer stores the setting an d then st arts
initializing. After that, the printer returns to the normal mode.
For detailed information about memory switches, see "Setting the Memory Switches and R/
E" on page 59
.
To Next Page
Loading...
