80
Scanning ID Cards
Follow the steps below to scan both sides of an ID card.
1
Put the ID card in the insertion slot on the right side of the pocket with its
photo side facing the pocket, and slide it along the bottom of the slot.
2
When the card starts feeding, release it immediately.
3
When the ID card is ejected and the ID Card LED flashes, remove the ID
card from the slot.
Use an ID card that meets the specifications. (See "Paper Specifications" on page 39.)
Make sure that the ID card is flat and does not have excessive bending, cracks, folds, or
embossing.
Do not touch the external terminal when using an IC card.
When the ID card is feeding, a part of it comes out of the card carrier slit at the back of
the product. Be sure not to block this slit.
Do not touch the ID card when it is being ejected. Doing so may cause distortion and
other problems with the scanned data.
Do not open the covers while processing is in progress.
To Next Page
Loading...
