Epson TM-S9000MJ - Printing and Cutting Positions for Roll Paper

42
Roll paper
Printing and Cutting Positions for Roll Paper
 Numeric values used here are typical values; the values may vary slightly as a result of
paper slack or variations in the paper. Take this into account when setting the cutting
position of the autocutter.
 The cut paper may be pulled at the uncut edge when it is removed, causing reduced
printing pitch for the first line of the next receipt. To prevent dot displacement, after
cutting, feed paper approximately 1 mm {14/360 in} or more before printing.
 When operating the autocutter after leaving the product unused for some time, feed
paper 40 mm {1.57 in} or longer to prevent paper jams in the autocutter unit.
72.20 mm {2.84 in}
79.50 ± 0.50 mm {3.13 ± 0.02 in}
3.70 ± 2.00 mm
{0.15 ± 0.079 in}
All the numeric values are typical,
Emergency cutter position
Autocutter position
Center of print head
Approx.
10.00 mm
Approx.
27.00 mm
Paper feed direction
All the numeric values are typical,