40
Roll paper
Paper type Specified thermal paper
Paper size Roll paper diameter 83 mm {3.27 in} maximum
Roll paper core Inside: 12 mm {0.47 in}
Outside: 18 mm {0.71 in}
Width: Must be the same as the paper width or less than
the paper width by 1 mm.
Take-up roll paper width 80 + 0.5/-1.0 mm {3.15 + 0.02/- 0.04 in}
Paper width 79.5 ± 0.5 mm {3.13 ± 0.02 in}
Specified roll paper type NTP080-80 [Original paper: TF50KS-E (Nippon Paper
Industries Co., Ltd.)]
In Japan: Nakagawa Manufacturing Co., Ltd.
In U.S.A.: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
Specified original paper type TF50KS-E, TF60KS-E (NIPPON Paper Industries Co., Ltd.)
PD150R, PD160R, PD190R (OJI Paper Mfg. Co., Ltd.)
P220AGB-1 (Mitsubishi Paper Mills Limited.)
P30023, P31023, P35023 (Kanzaki specialty Papers)
AF50KS-E (Jujo Thermal Oy)
F5041 (Mutsubishi HiTec)
KT55F20, KT48F20 (Koehler Paper Group)
Paper must not be pasted to the roll paper core.
If paper other than the specified paper is used, serious problems may occur, such as the
print head may be damaged, reliability of the product may decrease, or the print quality
may be poor.
It is recommended to avoid using preprinted thermal paper. If such paper must be used,
conduct preprinting test under the conditions (type of ink/print conditions) recommended
by the paper manufacturer and confirm that no faulty printing, print density, or any other
problems occur before you use it for actual printing.
To Next Page
Loading...
