Chapter 2 Setup
55
2
3
If there is a used ink cartridge, remove it by pulling up the tab on the top
of the cartridge while holding the product.
4
Remove a new ink cartridge from its package.
5
Install the ink cartridge in the correct direction, and push it until it clicks in
place.
6
Close the ink cartridge cover.
When you first use the product, installing an ink cartridge begins charging the ink supply.
Ink charging takes approximately four minutes and Power LED flashes during that time.
7
Make sure the Power LED turns on after flashing.
Do not tilt the product during ink charging to avoid ink leakage.
Be sure not to turn off the product or open the covers while the Power LED is flashing.
This restarts the ink charging, which wastes ink.
To Next Page
Loading...
