Chapter 2 Setup
61
2
Cut paper when the cover is closed
•Use this function (initial setting)
•Not use this function (not recommended)
Roll Paper Reduction Settings
•Extra Upper Space Reduction: Disable (initial setting) or Enable
•Extra Lower Space Reduction: Disable (initial setting) or Enable
•Line Space Reduction Rate: Not reduced (initial setting), 25%, 50%, or 75%
•Line Feed Reduction Rate: Not reduced (initial setting), 25%, 50%, or 75%
•Barcode Height Reduction Rate: Not reduced (initial setting), 25%, 50%, or 75%
Multi-tone print density
Selectable from levels 1 to 13 (70% ~ 130%). (initial setting: level 7)
Depending on the paper type, it is recommended to set the print density.
Time to check ink head cleaning
Time (hh:mm) is settable. (initial setting: 20:00)
Validation settings
•Top margin (initial setting: 0)
When the print density setting is too dark, the printing speed tends to drop.
When the print density setting is too dark, paper dust sticks to the print head surface,
often resulting in faded print. (For instructions on how to clean the thermal head, see
"Cleaning the Thermal Head" on page 82.)
Top margin (dots)
Left margin
(dots)
50.8 mm
18 mm
Print Area
10 mm
10 mm
Paper feed direction
To Next Page
Loading...
