Epson TM-T82X Technical Reference Guide

37
Chapter 3 Advanced Usage
2
After briefly (less than one second) pressing the Feed button once, hold it down for at
least one second, to print the NV graphics information.
After information printing, the Mode selection guidance is printed again.
3
To finish, turn off the power, or select “Exit and Reboot Printer”.
Receipt Enhancement Information Print Mode
You can check the following items using the R/E information mode:
• Auto top logo printing setting
• Auto bottom logo printing setting
• Extended settings for auto top/bottom logo printing
Follow the steps below.
1
After running a self-test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
2
After briefly (less than one second) pressing the Feed button twice, hold it down for
at least one second, to print the R/E information.
After information printing, the Mode selection guidance is printed again.
3
To finish, turn off the power, or select “Exit and Reboot Printer”.
Software Setting Mode
You can change the printer settings. For information on available setting items, see "Software Settings" on page 26.
Follow the steps below.
1
After running a self-test, hold down the Feed button for at least one second to enter
the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.

Epson TM-T82X Specifications

General

Print Method	Thermal line printing
Paper Width	80 mm
Autocutter	Yes
Power Supply	AC 100-240V, 50/60 Hz
Paper Roll Diameter	83 mm
Interface	USB, Ethernet
Dimensions	140 x 199 x 146 mm
Resolution	203 dpi x 203 dpi