Epson TM-T82X Technical Reference Guide

56
Chapter 6 Replacement of the TM-T82
Replacement of the TM-T82
The TM-T82X is designed so that it can smoothly replace the TM-T82. This chapter describes precautions for
the replacement.
Compatibility
Printing
The printing and character specifications are the same as those of the TM-T82.
Without special configurations, the TM-T82X prints the same results as the TM-T82 prints.
Print Speed
The TM-T82X prints faster than the TM-T82.
Cutting Method
TM-T82X uses the same partial cutting method as the TM-T82 uses, but the point left uncut has been changed
from one point in the left edge to one point at the center.
Logo Registration
The TM-T82X can register logos in the NV memory (NVRAM) with the Setup Utilities.
Driver Compatibility
You can operate the TM-T82X with a driver for the TM-T82.
USB Low Power Consumption Mode
With the TM-T82X, you can enable the USB low power consumption mode using the Epson TM-T82X Utility.
TM-T82X TM-T82
Maximum print speed Up to 200 mm/s Up to 150 mm/s
Print speed setting Level 1 to 13 Level 1 to 13
Depending on print conditions such as print duty, print head temperature, and data transmission
speed, print speed is automatically adjusted.

Epson TM-T82X Specifications

General

Print Method	Thermal line printing
Paper Width	80 mm
Autocutter	Yes
Power Supply	AC 100-240V, 50/60 Hz
Paper Roll Diameter	83 mm
Interface	USB, Ethernet
Dimensions	140 x 199 x 146 mm
Resolution	203 dpi x 203 dpi