Epson TM T88IV

40
For USB Interface
DIP switch bank 1
DIP switch bank 2
SW Function ON OFF
Factory
setting
1-1 Auto line feed Always enabled Always disabled OFF
1-2 Receive buffer capacity 45 bytes 4 KB OFF
1-3 ∼
1-7
Undefined — — OFF
1-8
Setting of USB power-saving
function
Disabled Enabled OFF
SW Function ON OFF
Factory
setting
2-1 Handshaking (BUSY condition) Receive buffer full
• Offline
• Receive buffer full
OFF
2-2
Reserved (Do not change
setting)
Fixed to OFF OFF
2-3 ∼
2-4
Selects print density/Low
power consumption mode
See "Selecting the Print Density (DIP Switch
2-3/2-4)" on page 41.
OFF
2-5
Setting the release condition
of the receive buffer BUSY
state (This function is effective
when DIP switch 1-2 is set to
off.)
Releases the BUSY
state when the
remaining capacity
of the receive
buffer reaches 138
bytes.
Releases the BUSY
state when the
remaining capacity
of the receive
buffer reaches 256
bytes.
OFF
2-6 ∼
2-7
Reserved (Do not change
setting)
Fixed to OFF OFF
2-8
Reserved (Do not change
setting)
Fixed to ON ON
• For DIP switch 2-1 (BUSY condition), see also "Selecting the BUSY Status" on page 42.
• Do not change the setting of DIP switches 2-2, 2-6, and 2-7. Otherwise, the printer may
not operate normally.