Epson TM T88IV

74
Number of Head Energizing Parts
For the TM-T88IV, the initial setting of the number of head energizing parts is “Auto
energizing.” You can change the setting to a customized value (See "Setting the Memory
Switches" on page 43.); however it does not usually need to be changed.
Printable Area
The printable area (left/right margins, print start position from the autocutting position, print
start position from the manual cutting position) of the TM-T88IV is the same as that of the
TM-T88III.
Cutting Method
The TM-T88IV uses the partial cutting method (cutting with one point in left edge left uncut) as
does the TM-T88III.
Receive Buffer
You can set the receive buffer of the TM-T88IV to 4KB or 45 bytes with DIP switch 1-2 as with the
TM-T88III. The buffer full condition and buffer full release condition of the TM-T88IV are the
same as those of the TM-T88III.
Memory Capacity
The sizes of the download buffer and NV graphics data of the TM-T88IV are the same as those of
the TM-T88III. The TM-T88IV does not have the NV user memory.
TM-T88IV TM-T88III
Number of head energizing part • One-part energizing
• Two-part energizing
• Four-part energizing
• Auto energizing
Fixed to two-part energizing