Epson TM-U590 - For Parallel Interface

Chapter 2 Setup
29
2
For Parallel Interface
DIP switch bank 1
DIP switch bank 2
SW Function ON OFF
Factory
setting
1-1 Auto line feed Always enabled Always disabled OFF
1-2 Receive buffer capacity 69 bytes 4 KB OFF
1-3 ∼
1-8
Undefined — — OFF
If you turn on DIP switch 2-7 or 2-8 while the printer power is turned on, the printer may be
reset, depending on the signal state. DIP switches should not be changed while the printer
power is on.
SW Function ON OFF
Factory
setting
2-1 Handshaking (BUSY condition)
• Receive buffer full
• Reading data
• Offline
• Receive buffer full
• Reading data
OFF
2-2
Reserved (Do not change
settings)
Fixed to OFF OFF
2-3 ∼
2-4
Undefined — — OFF
2-5 ∼
2-7
Reserved (Do not change
settings)
Fixed to OFF OFF
2-8
IF pin 31 reset signal (Do not
change settings)
Fixed to ON ON
For DIP switch 2-1 (BUSY condition), see also "Selecting the BUSY Status" on page 30.