A-2 Comparison table for TM-U220/U210/U300
Rev. D
TM-U300 (Type A, B, C,
D) TM-U210 (Type A, B, D) TM-U220 (Type A, B, D)
Paper supply
functions
Roll Paper install method Paper roll holding
shaft
Paper roll drop in <==
Paper roll setting Auto-loading Auto-loading 1-2-3 setting
Paper end detector Yes Yes <==
Paper near-end detector Yes Option Factory option.
Cover open detector Yes No Yes
Validation detector Yes (Option for type
C, D)
No Validation function <==
Paper feed method Friction feed Friction feed <==
Paper feed length Default 4.23mm(1/6
inches): changeable
by command
Default 4.23mm(1/6
inches): changeable
by command
<==
Paper feed speed 25 lines/sec 25 lines/sec 30 lines/sec
Paper
specification
Paper roll dimensions Paper width:76mm,
Roll diameter:
max.83mm
Paper width:76mm,
Roll diameter:
max.83mm
Paper width:
76mm (Type A)
76mm / 69.5mm / 57.5mm (Type B, D)
Roll diameter: max 83mm
Normal paper Paper thickness:
0.06 ~ 0.085mm
Paper thickness:
0.06 ~ 0.085mm
<==
Carbon
paper
Number of copies Original + 1 copies
Original + 2 copies (at
temperature approx.
25C°)
(Copy mode need to
be set by command)
Original + 1 copies
Original + 2 copies
(type D only)
Original + 1 copies (for all type A, B, D)
Validation paper Type C, D only Not supported <==
To Next Page
Loading...
