Rev. D Setup 3-3
TM-U220 Technical Reference Guide
PAPER OUT
Note:
The roll paper near-end sensor is available as an factory option. If the printer is not equipped with the roll paper
near-end sensor, the roll paper near-end is always detected as paper present.
See “Adjusting Position of Roll
Paper Near End Detector” (page 3-27) for information on adjusting the detector.
3.1.2.2 Control Panel Buttons
The control panel has paper button that you may have to use, although most paper handling
functions will be handled by your software.
FEED
Use this button to feed roll paper or to start a roll paper self test. (See “Self Test Procedure” (page
3-40).)
Note:
The FEED button can be disabled by using an ESC/POS command. Refer to “ESC/POS Application
Programming Guide” for details.
On: The roll paper near end (*1) or real end is detected.
Off: Paper is loaded (normal condition).
Flashing: Self-test waiting state for test print.
To Next Page
Loading...
Need help?
General