VT6L Maintenance 5. Backup and Restore
VT series Maintenance Manual Rev.2 23
Password authentication setting
This checkbox allows you to restore the setting of authentication for PC connection.
The authentication password for PC connection and the setting to disable
connection authentication are restored.
This is not selected by the default setting.
(5) Click the <OK> button to restore the system information.
Restore the system configuration saved using Backup Controller only for the same system.
When different system information is restored, the following warning message appears.
Click the <No> button (do not restore data) except for special situations such a
Manipulator replacement.
When restoring the backup including the robot information other than VT series, an error
occurs.
You cannot restore the backup including T series robot created in the virtual Controller of
EPSON RC+ 7.0 to the VT series robot.
To Next Page
Loading...
