435
• Do not press too hard on the scanner glass when placing originals.
• Do not open the scanner section while the product is copying, printing, scanning, or performing any
other functions.
• Be careful not to trap your fingers when opening the covers, trays, cassettes, or when performing
operations inside the product.
• Avoid touching the components inside the product unless as specifically instructed to do so in this
guide.
• Except as specifically explained in your documentation, do not attempt to service or disassemble the
product yourself.
• Unplug the product and refer servicing to qualified service personnel under the following conditions: if
the power cord or plug is damaged; if liquid has entered the product; if the product has been dropped
or the case damaged; if the product does not operate normally or exhibits a distinct change in
performance. Adjust only those controls that are covered by the operating instructions.
• Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and may
prevent the product from printing.
• When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside down;
otherwise, ink may leak.
• Do not attempt to move the product by yourself.
• Make sure the adjuster bolts are locked when using the product. Do not move the product when the
adjuster bolts are locked.
• If the optional booklet finisher is installed on your product, use a power cord for the product and
another power cord for the booklet finisher. The rated current of the product is 9 A, and the booklet
finisher is 10 A. Connect the power cords to a power supply with a capacity larger than the total rated
current. If the total rated current exceeds the power capacity, connect each power cord to a separate
power source with an independent switchboard breaker.
• Do not touch the areas indicated by caution labels inside the product and any optional items.
To Next Page
Loading...
Need help?
General
